Super Clean Degreaser to remove lettering
A&Y Dave in MD
I went to the Dollar Store today and picked up a bottle of this stuff. Poured a small amount into a cup leftover from Nyquil. Dipped a cotton swab in the solution to wet the tip without drenching it. Applied the damp tip to the number on a Kadee boxcar (one of the new Southern ones I got yesterday). Less than two minutes of scrubbing showed the numbering was coming off. Within five minutes the number was gone. The paint color could be seen on the swab, so it would remove the paint if you aren't careful. I used the dry end of the cotton swab to wipe the area clean after the numeral was off. I'm going to let it dry. I probably should have washed it with water to ensure no further loosening of the paint. But with the minimal amount of cleaner on the swab it seemed to evaporate fairly quickly.
It is much harder to remove the numeral on the end, but only because the size is so small and the contours of the end make it difficult to rub a swab. I'll experiment with a toothpick and/or a microbrush later, once the sides are dried and sealed.
So Super Clean degreaser works on Accurail and Kadee lettering! And at $1 for a 20 oz. bottle, I have a lifetime supply. Nice!
I'll use my Ghost White Toner to print the new numerals. The Kadee car apparently only came in one number so far. I ordered two cars, hoping for two numbers. This thread was timed well! The car is a '48 build, so this will be for the FCSME 1955 era layout instead of my '34 era home layout. The car was well done and even though I have a ton of '55 era cars these were too good to pass up for this "y'all road" modeler. Maybe I'll use the degreaser to remove the packing year and replace that for '53 or so.
Friday, May 24, 2019, 1:57:18 AM, you wrote:
Super Clean degreaser will lift lettering from Accurail cars in less than two hours without affecting the paint – unless you soak cars for a week and scrub hard with a toothbrush. I haven’t tried to selectively remove lettering or used it on Walthers cars.
You are receiving this email because you are subscribed to main@RealSTMFC.groups.io via dbott@.... You can unsubscribe here.
Sent from David Bott's desktop PC
David Bott, modeling the A&Y in '34