well done!

On 5/26/2019 12:28 PM, StephenK wrote:

After potting around with this for a few weeks, I finally got a good result.   I tried several ways of pressing aluminum foil on the outside of the door, but nothing would get the detail to show properly.   An attempt at using strip styrene was more trouble than it was worth.  In addition, I realized that the kit door had latch detail molded in which would show on the inside.  I ended up making a simple casting.   I used a similar door out of my stash and carved off the latches, etc.   I attached the door to a sheet of plastic and poured Elmer's School Glue over the door.   I poked around in it to remove the bubbles and let it dry overnight.   The next day the glue was mostly dry and peeled off easily.  I ACC's it to the kit door, trimmed the excess and painted it Floquil Old Silver.   A little rust powder, and the door was done.   

A few other notes:  The wood interior walls had to be trimmed a bit to clear the kit roof.   I chose not to use the wood floor from the interior kit because it added a layer to the car that I though looked wrong--I painted the plastic kit floor instead.    I built bulkheads at each end of the car and filled the space with BBs for weight--a normal interior weight would add to the floor height and again I didn't want that.   I have left the car unweathered and the roof unattached until I decide what the load should be and get it built and installed (a car carrying bags of flour will have different weathering than a car carrying boxes of  merchandise).  In any case, the kit went together well and I am happy with the result.  

Attachments:

• IMG_2733.jpg

--

Fenton Wells
250 Frye Rd

Pinehurst NC 28374
910-420-8106
srrfan1401@...