On Sun, Jun 9, 2019 at 04:07 PM, Jack Mullen wrote:
On Sat, Jun 8, 2019 at 08:00 PM, Schuyler Larrabee wrote:
Indeed, and if you look around in the photo Schuyler linked, you'll see steps on the Rio Grande and WLE boxcars are also bent inward. Must be operating on a club layout. ("Huh, THAT isn't very sturdy! I build MY cars to OPERATE.")
It’s pretty clear that the steps ARE bent inwards from the usual plane of the car side.
Seriously, once to start looking, you'll see these a lot. The bend is by design, not damage (though that happens too). It's a consequence of the inward taper of the clearance envelope below the level of the side sill. When the inside width of house cars expanded to 9'2", width over the side sills became about 9'10". But the bottom of the step is at a height of 2' or a couple inches less ATR , where the max width has reduced to about 9'8".
Attached is a photo showing two views of an undamaged sill step on D&RGW Pressed Steel boxcar 69332 showing the designed-in bend. It's the step on the right. Pierre offers this step, Yarmouth part #YMW-216.