Re: MWR 1201-1275 series Mather Patent Boxcar help - correction, sorry
toggle quoted messageShow quoted text
Mont, thank you for all of your high quality modeling articles over a long time span that showed us that we could do it and you kept Mainline Modeler going and going! I always appreciated your list of items needed for each model, allowing me to order the material not in one of my storage boxes!
Northwest of Mike Brock
From: main@RealSTMFC.groups.io <main@RealSTMFC.groups.io> On Behalf Of Mont Switzer
Sent: Monday, May 25, 2020 12:55 PM
Subject: Re: [RealSTMFC] MWR 1201-1275 series Mather Patent Boxcar help - correction, sorry
This is correct. The small U channel diagonals are the ones I prefer to remove or copy from the LL Proto model than build them up per the SS instructions.
SS wants you to stand either .010 x .020 or .010 x .030 styrene strip stock on end and cement it to the car sides to form the U channels.
You are correct that the stock car channels are too short. You have to splice them or use them to make a longer master to cast what you need in resin.
FYI, the MWR Mather boxcars hauled Ball Glass Manufacturing Co. blue glass canning jars made in Muncie, IN, all over the country and photos verify the cars could be seen just about anywhere. The Mather design cars served the MWR into the late 1950's when they were replaced with a fleet of singe sheathed composite cars rebuilt with steel sides.
The steel cars had both 8 and 10 panel sides. The steel cars were also yellow, but they did not paint the canning jar on the corrugated doors. RMC has an article on these cars.
From: main@RealSTMFC.groups.io [main@RealSTMFC.groups.io] on behalf of Chuck Cover [chuck.cover@...]
As often happens when I comment, I made a mistake. I should have said that the verticals on the Sunshine Mather boxcar kits are Z bracing, NOT the diagonals. I don’t believe that the P-2000 models have this Z bracing on the verticals.
Santa Fe, NM