Re: Using Pledge

Mont Switzer



I store my Future in small Floquil size bottles.  It can over time get a little “stiff,” at lease in the small bottles.  Distilled water takes care of that.




Montford L. Switzer


Switzer Tank Lines, Inc.

Fall Creek Leasing, LLC.


(765) 836-2914


From: <> On Behalf Of Douglas Harding
Sent: Wednesday, September 23, 2020 8:21 AM
Subject: Re: [RealSTMFC] Using Pledge


The Pledge/Future floor finish product is 100% clear acrylic. No need to thin for airbrushing. It can also be brushed on, good for small areas. Clean up with water. It provides a gloss finish perfect for decals. I have created a flat finish by mixing Tamiya Flat Base with, at a 10 to 1 ratio.


Doug Harding


From: <> On Behalf Of lsittler
Sent: Wednesday, September 23, 2020 5:40 AM
Subject: [RealSTMFC] Using Pledge


Good morning- I have been using Pledge to affix rivet decals to plastic and resin, based on the advice from Bill Welch and others in this group. It has worked very well. In those cases, I was brushing Pledge in the areas where the rivets were to be placed. But I have read that others use Pledge as a finish coat before applying decals. I am assuming that in those cases, Pledge was applied over  acrylic paint such as Polyscale, due to the flat finish of those paints, correct? Do you spray it on? If so, do you thin it? And what's the thinner? Or do you brush it in the areas where the decals go? Also, I'm thinking that with a paint like Scalecoat 2, this would be unnecessary since that paint has a gloss finish already  and  decals can be applied right on top. Any advice would be most appreciated. Thanks. Les

Join to automatically receive all group messages.