Re: Etched brass parts was Re: [RealSTMFC] Frisco “Sawtooth” boxcar photo


steve_wintner
 

I suppose one could etch a simple L with the holes. Design it for one peaked roof, file it to match the radial roof if needed. Then use a short stub of styrene to support the center of the L, under the central board. That'd look ok from some angles, but not all. In the same fashion, a stub of PB wire into a hole in the roof could support the etched L, might look better. (Kinda like moloco did, except in metal.) Fiddly though. 

Steve

Join main@RealSTMFC.groups.io to automatically receive all group messages.