Re: New YouTube video...
|
Jack Burgess <jack@...>
Thanks Gary…I was gone all day but you confirmed my statement. I had been doing this for years but went online to confirm my understanding before we made that video…
Jack
From: main@RealSTMFC.groups.io [mailto:main@RealSTMFC.groups.io] On Behalf Of Gary Roe
Sent: Tuesday, June 29, 2021 5:13 PM To: main@RealSTMFC.groups.io Subject: Re: [RealSTMFC] New YouTube video...
Bob, Yes, that is the way I understood it as well.
gary roe quincy, illinois
On Tuesday, June 29, 2021, 07:09:20 PM CDT, Bob Chaparro via groups.io <chiefbobbb@...> wrote:
If I am understanding the proper use of the drill bit gauge Jack discusses at 13:35, you test the drill bit in successively smaller holes until it will not fit into a hole. That hole indicates the proper drill bit size, correct? |
|
|