Re: [EXT] Re: [RealSTMFC] 3D Printing Trucks?

Bruce Smith

Dennis, Folks,

The bearings are available as a separate part



Bruce Smith

Auburn AL


From: <> on behalf of Dennis Storzek <dennis@...>
Reply-To: "" <>
Date: Friday, December 3, 2021 at 3:38 PM
To: "" <>
Subject: [EXT] Re: [RealSTMFC] 3D Printing Trucks?


CAUTION: Email Originated Outside of Auburn.

On Fri, Dec 3, 2021 at 12:19 PM, Jim Betz wrote:

What I don't know is whether or not
they would operate as well as the typical Delrin trucks.

Well, they will be more fragile. If you are worried about bearing wear, you might design them to use the nylon bearing inserts that Tichy designed into the 100 ton wrecker trucks. As I recall, these fit into a 3/32" diameter cylindrical hole (but don't design the part until you measure the bearings) and provide the standard 60* cone shaped bearing in a tougher material. I don't see these on the Tichy web site as a separate part, but Don is easy to deal with, so contact him and ask.

Dennis Storzek

Join to automatically receive all group messages.