Use the search box at the top left of the screen with the purple "Search Groups" and blue "Search Web" buttons to the right. (You'd think, bein' matrix and all, they would have been red and blue

And frankly, if this mean and thoughtless witch hunt does not sour the experience for those folks trying to do something to promote RPM to the point they don't wish to do it again and if there is an

I must say I am dismayed by the number of persons on this list who should know better jumping on the bandwagon to trash folks trying to do some good before even trying to get the facts. Sure, take the

Mr. Valentine, Thank you for not continuing the excessive flaming that characterized your previous post on this subject. I for one welcome the opportunity to attend an RPM meet at a location that is

Correction Tom, The post was put on the STMFC and PCL less than 24 hours apart, the first on Thurs. morning and the other on yesterday, which is not several days ago either. As Alex schneider

I just checked my incoming "E" mails and Rich Orr clarified the PRM problem. As they said facility was not Handicap accessible, and if they had added, that due to it's size, Number of people it could

This is not a phony RPM. I will be attending and presenting a talk on Friday evening. The organizers have been advertising this since early last year. They got the location locked down in April and

I DID NOT RECEIVED "E" MAIL FROM DON VALENTINE. PLEASE FORWARD, Bob DeMoss

Good evening group, I just picked up an Atlas Trainmaster kit for this car on an impulse. Does anyone have a photo of one pre 1954 so I can see how much work I have in front of me. I can't get the

Would you prefer they keep registration open and when you arrive there is no place for you? There is nothing snobbish about being honest. This is a first attempt by a small group without any idea of

2-Ton Epoxy is a good conventional, if pricey product (because of its small packaging). Other packaged similar slow-setting epoxies should serve just as well. They all can serve as a fillers,

Hello All, Just a few points about the upcoming RPM meet here in Virginia in response to this very negative post. I am not one of the organizers but I am one of the invited clinicians. While Mr.

Don, I don't know any of the folks going toor arranging the RPM at Stafford, but about 8 months ago I registered to go.It's about a 4 hour drive from Lynchburg ut I wanted to see what all

I looked at their website and also noted Don's comment about limiting the attendance to 40 persons. As Tom noted, obviously they are going to sell out if they hold such an event in a small facility.

Don put this same post on the Passenger Car List several days ago and did not receive much support for his position. I gather this is a group of established modelers trying to do something positive.

A long time ago, in a far off area of the Nation, a much younger Bill Welch organized a one day modelers meet in Pasadena, CA. Because of the lack of space, his offered free meeting space limited how

There's a large Yahoo group devoted to the subject of casting! There is information there about putties and Devcon products. http://groups.yahoo.com/neo/groups/casting/ Tim O'Connor

And if it doesn't strip your paint, well, you can clean the bathroom withit. Try that with Chameleon or lacquer thinner! Tim O'Connor

Reginald, It is the one that looks yellow... Kinda like, well you know... Tall bottle with Red writing. Sorry I should have been more specific. Greg Martin

Bob DeMoss wrote: Read the email from Don Valentine. Tony Thompson Editor, Signature Press, Berkeley, CA 2906 Forest Ave., Berkeley, CA 94705 www.signaturepress.com (510)