Hi Bud, There is a Jim Parker picture of one at Niagara Falls NY on the Canada Southern website, pretty close? http://www.canadasouthern.com/caso/non-nyc/images/bck-1861.jpg Hope it may help,

Asking for a friend from Canada, he wanted to know if the Buffalo Creek boxcars ever went to Canada, loaded with flour I presume? While I formerly once worked for the BCK, I have no clue this many

Stephen, Thanks, another fellow sent me this too. It sure looks like a GATC radial course 8000gal car. If you look close, it appears a repair panel was riveted on the left end. Now, I need a couple of

Many oil companies reserved the silver schemes for local dealer delivery. It’s possible that CONX did so too. Tony Thompson tony@...

This photo was floating around the internet not too long ago. J. Stephen Sandifer

Thanks, but I am not interested in any at this time. -Andy Carlson Ojai CA

I'd be interested in a couple. Jeff Whte Alma IL On 11/4/2021 8:49 AM, Frank Hodina wrote:

Michael and Group; One of the coolest gons of all time was the G25 “Screw Car(s)”. PRR didn’t much like their USRA cars, and they had wooden floors, and interior folding stake pockets,

I’d certainly like a pair. Will they be made with cast on grabs or will the modeler have to install wire grabs. I’m for the latter. Billy

The story did get written recently here. Did you not get it? Tony Thompson tony@...

 Hi Bill and List Members, Thanks for the info. I model in N scale, and Micro-Trains makes an N scale twin hopper that is a close match to the Athearn HO twin hopper. So there is a nice

Eric Hansmann just sent me a scan of the Westerfield USRA gon instructions, so I am good to go. Thanks to Eric, Elden Gatwood, and others who offered advice, photos, or reference material. Cheers! --

Yes, I’d buy a few. Nelson Moyer

Thanks to everyone for your helpful replies and for sending reference materials and photographs. Yes, it appears the Free State Carmer levers are no longer available, but I may be able to fashion

Buy some Burlington hoppers? Yes, definitely...but NOT after I spend 40 hours rebuilding a couple of old BB dogs. I haven't studied the rosters yet but Burlington had around 4,000 of these cars.

Michael; These ought to give you enough on the B end details to execute the resin parts build. G25 Carmers had that big step-up on either side of the pivot bolt. Note the PRR as-built had

Hey gang, I'm revisiting my research on a particular block of D-X (C.O.S.X) tank cars. The cars appear in the attached W. Middleton photo that was poorly reproduced in the CERA "Iowa Trolleys" book.

Tom, and Everyone, Thank You for the photos! I must've got a hundred photos from all directions. They're very helpful and I have enough to do the project. The photo you linked to is the best one I

Group; Once I figured out what the end details should look like, the Westerfield resin details went on OK, including the cut levers. You could try that source. Keep in mind the pivoting

I definitely would be interested. Rich Christie On Thursday, November 4, 2021, 09:25:15 AM CDT, William Hirt