Group, of course this was not intended to go to the group... I apologize. Johannes Gesendet: Sonntag, 09. Juli 2017 um 22:31 Uhr Von: "j.markwart@... [STMFC]" An: STMFC@... Betreff: Aw: [STMFC]

Hello Andy, am I correct with the assumption that I was not the first interested party because you still didn't reply to my note? Many thanks and regards Johannes Gesendet: Samstag, 08. Juli

Thanks Bruce, I've seen the replies in the past that the info is in conversation history and in the photos section, and I think "what a newbie". Until now when it is my turn! Ya know, I searched all

Perhaps this: http://www.ebay.com/itm/Intraoral-Orthodontic-ArchWire-Square-016-X-016-Upper-Lower-20-MORELLI-/151702206569 Ed Edward Sutorik

I was not being picky as I can adapt anything Bill Welch

Until recently I was unaware the ExactRail had done a 42-ft General Steel Castings flat car and the Revenue Service schemes are sold, but I was able to find one very reasonable on Ebay. Since purchase

Jim The car in question has a normal door covered with paper or sheet of some other material tacked to it with strips of wood....not a solid reefer or plug door. Charlie Vlk

Bill, An underframe for which car? Yours Aye, Garth

Bill, I have a complete Intermountain 40' boxcar kit you can have for the cost of mailing. Jim

I now have been promised one underframe so please ignore my previous message. Bill Welch

Two Terry Weggman PFE R30-18 kits I have just built. Weathered using MIG Powders and sealed with Citadel purity seal.Paul Doggett UK  Sent from Yahoo Mail on Android [Non-text portions of this

IM lists these but have no idea if in stock or not. P40700-16 Underframe 1937 AAR 40' Boxcar 4 sets $4.95

​RJ, There are several photos in the Miscellaneous album on the group page. There include an N&W automobile car with the Evans loaders down and in position to receive a car as well as a photo with

Anyone have a spare InterMountain 40-foot Underframe they can spare for a few $'s? If so please contact me OFFLINE at fgexbill(at)tampabay.rr.com Thank you Bill Welch

Thanks to all who replied with assistance. Beyond the Xuron 488’s that Lester mentions, I now remember the other brand/model that I had looked at: Swanstrom Round-Nose Pliers. I think these were

RJ, you may find this interesting. From the June, 1934 issue of the N&W employee magazine. Matt Goodman Columbus, Ohio Sent from my mobile

Just google Automobile box car and look at the images. There are a number of them. J. Stephen Sandifer

I've never actually seen pictures of loading/unloading of driveable cars in Automobile boxcars. Mainly interested in the 1930s-1940's. Are there any? From period newspaper accounts I gather that is

Matt you asked about bending eyebolts for model use. I have done so for many years. I currently use the Xuron 488 wire bending pliers to make eye bolts which I have found to be the best plier when I

The PSC eyebolts are cast. Schuyler I use Yarmouth model works etched eyebolts instead of bent wire versions. They come in several sizes, and they are a vast improvement over wire. Pierre mails