That should be not far from Victorville Don Ford Cameron MO

the containers look some thing like parts for airplanes or some other kind of ordnance. The Marine supply depot is far for Victorville Don Ford Cameron MO

Bill In the may 2008 issue of RMC on pages 60-65 by James Kinkaid there are 3 pictures of G22b in container service with three different crown type trucks. One is very much like the trucks on our Rail

Tim The wheel base and the side height is different. The hoppers are orientated all facing to the center were as the H21a is a saw tooth arrangement. the hopper doors are a corrugated style I think ca

David There is also a picture of this car on page 68 of Pittsburgh and Lake Eire by Harold H. McLean (Golden West Books 1980). The author states that the car was either built by P&LE in the McKees Roc

Group i have two sets of Mercury Euclid TS-24 double engine scrapers that came with a blade mounted crawler tractor and a rubber tired front end loader. I think they were promotional gifts of Euclid.

Tim I have a builder photo of No. 37000 dated June 1957 Don Ford Cameron MO

Group Mainline Modeler July 1983 page 75 has photo of #70498, and #71298 (as built) Mainline Modeler July 2004 page 38-39 photo of 71298 with lettering diagram Don Ford Cameron MO

This was my 4th Collinsville Meet best yet great clinics, outstanding models, the vendors must have been good my pocket book is a lot lighter, my jaw is worn out, great time. Thanks to all that put th

Tim Thanks Don Ford Cameron Missouri

Thanks Ed Don Ford Cameron Missouri

Group Going thru some old kit that have been in storage came a upon a CB&T car #26451 with the broken wing scheme - foobe or not? Also a GM&O #24579 End Cab model double door 40-foot car broken wing s

I also received mine copy yesterday OUTSTANDING! Don Ford Cameron MO On Saturday, April 1, 2017 8:55 PM, "'Douglas Harding' doug.harding@... [STMFC]" Mine arrived the other day. 192 page

Group the H21 had 2508 cubic feet capacity with the old style hoppers. In one of the photos of the top view notice the next car it has partial bulb angles on it this was an early problem with putting

Bill they used two pieces of Evergreen #4528 corrugated siding with spacing between grooves of 0.080". They used 0.010" soft tinned copper wire. Don Ford Cameron MO

they are called Deco or dot in grid ends only found on this series of C&O boxcars Don Ford

Group I use the PSC valve but leave it on the spur give it a little twist and drill it #80 and when ready to install then remove it just did a bunch for PRR N5 and N5b cabins (two per car) Don Ford Ca

Bob this car was part of a gun car built to haul coast artillery gun barrels. the other car was numbered 50001 and they had a special gun carriage suspended between them. When the design of the guns w

Jim These 30 cars came from the DT&I the two (2) photos I have one shows the A end clearly does not have a end door #7020 the other photo is side view and does not have the heavy corner of a end door

Aaron the 47000 series had 4/4 dreadnaugh end with the corrugations beveled off the the end of the ribs and Hutchins dry lading roof they came with Youngstown dors but some got 5 or 6 panel Surerior d